Production Estimating Program for 750C-II, 850C-II, 950C and 1050C Crawler Dozers Spreading Truck Transported Material

ESTIMATING PURPOSES ONLY
Enter data in shaded cells according to instructions Place cursor over red triangles for information.
  Use tab key  
A. Truck payload, from 12 to 35 loose cubic yards:  
Use average payload if truck size varies. The width of the spoil pile will vary according to payload.
The estimator calculates using the width of the spoil pile moved forward rectangularly at the  
desired lift. Larger payloads require more spreading distance but fewer transitions from spoil  
pile to spoil pile.      
 
B. Lift required in inches:  
Enter thickness of spread material.  
 
C. Distance lift starts beyond front edge of stockpile in feet: Leave blank if it does not apply.
On some jobsites, material cannot be off-loaded at the point it will be spread. In this case enter
the average distance from the spoil pile to where the lift begins.  
   
D. Adverse Grade Percent: Leave blank if it does not apply.  
If pushing uphill, enter the percent (from 1 to 30) in whole numbers.  
       
             
E. Adjustment for non-average material:  
Enter an x in the shaded cell to any of the following conditions that apply.  
  Heavy, over 2,800 lb. Per LCY:  
  Sticky:  
  Very dry and non-cohesive:  
         
F. Operator Skill      
Enter an x in the shaded cell that applies.    
    Skilled    
  Average    
  Below Average  
 
Production Estimates for 750C-II and Larger Crawler Dozers
50 Minute Hour
  LCY   LCY
Model Blade   Production Model Blade   Production
 
850C-II LT Semi-U, Hi-Production   750C-II LT Semi-U, Hi-Production
850C-II LT PAT     750C-II LT PAT  
850C-II WT Semi-U, Hi-Production   750C-II LT SU, Lo-Profile
850C-II WT PAT     750C-II WT Semi-U, Hi-Production
850C-II LGP Semi-U, Hi-Production   750C-II WT Straight  
850C-II LGP PAT     750C-II LGP PAT  
950C Semi-U    
1050C Semi-U